in analytic chemistry, an electrochemical method of analyzing solutions of reducible or oxidizable substances. It was invented by a Czech chemist, Jaroslav Heyrovský (Heyrovský, Jaroslav), in 1922.

The majority of the chemical elements can be identified by polarographic analysis, and the method is applicable to the analysis of alloys and to various inorganic compounds. Polarography is also used to identify numerous types of organic compounds and to study chemical equilibria and rates of reactions in solutions.

The solution to be analyzed is placed in a glass cell containing two electrodes. One electrode consists of a glass capillary tube from which mercury slowly flows in drops, and the other is commonly a pool of mercury. The cell is connected in series with a galvanometer (for measuring the flow of current (electric current)) in an electrical circuit that contains a battery or other source of direct current and a device for varying the voltage applied to the electrodes from zero up to about two volts. With the dropping mercury electrode connected (usually) to the negative side of the polarizing voltage, the voltage is increased by small increments, and the corresponding current is observed on the galvanometer. The current is very small until the applied voltage is increased to a value large enough to cause the substance being determined to be reduced at the dropping mercury electrode. The current increases rapidly at first as the applied voltage is increased above this critical value but gradually attains a limiting value and remains more or less constant as the voltage is increased further. The critical voltage required to cause the rapid increase in current is characteristic of, and also serves to identify, the substance that is being reduced (qualitative analysis) (qualitative chemical analysis). Under proper conditions the constant limiting current is governed by the rates of diffusion of the reducible substance up to the surface of the mercury drops, and its magnitude constitutes a measure of the concentration of the reducible substance (quantitative analysis) (quantitative chemical analysis). Limiting currents also result from the oxidation of certain oxidizable substances when the dropping electrode is the anode.

When the solution contains several substances that are reduced or oxidized at different voltages, the current-voltage curve shows a separate current increase (polarographic wave) and limiting current for each. The method is thus useful in detecting and determining several substances simultaneously and is applicable to relatively small concentrations—e.g., 10⁻⁶ up to about 0.01 mole per litre, or approximately 1 to 1,000 parts per 1,000,000.